Win a free furnace replacement. Apply by Dec 9
CSLB #1023360

Supporting article · 7-minute read · Last reviewed October 2026

Heating and cooling an ADU, garage conversion, or addition

For most California ADUs, garage conversions, and room additions, a ductless mini-split is the simplest way to add heating and cooling: it needs no ductwork, gives the space its own controls, and doesn't load the main house's system. The energy code path depends on the project: the California Energy Commission treats a newly built ADU differently from an ADU created inside existing space. Your designer and contractor should settle the compliance approach before equipment is selected.

Reviewed by Vasiliy BardadinOwner & Lead Technician, Statewide HVAC · CSLB #1023360

On this page · 5 sections
  1. 01Why the main system usually shouldn't serve the new space
  2. 02How the energy code classifies the project
  3. 03Garage conversions: the envelope comes first
  4. 04Choosing head type and placement for small spaces
  5. 05Electrical: the overlooked constraint

Why the main system usually shouldn't serve the new space

Extending ducts from the house to a new ADU or addition sounds simple, but the existing furnace or AC was sized for the existing house. Adding several hundred square feet of load can leave both spaces short on the hottest afternoons.

For a separate dwelling unit there is also a code issue. Return air can't be shared between dwelling units under the mechanical code, and an ADU's occupants need their own thermostat. A dedicated mini-split solves both problems: separate equipment, separate controls, no shared air.

How the energy code classifies the project

California's energy code (Title 24, Part 6) treats projects differently depending on what is being built. In its ADU guidance, the California Energy Commission says a newly constructed ADU follows the rules for new construction, while an ADU created by converting existing space follows the rules for additions and alterations. Garage conversions are their own case, because the garage was unconditioned space before the project.

The classification determines which forms, efficiency requirements, and HERS verifications apply. New ADUs are also subject to whole-dwelling mechanical ventilation requirements for indoor air quality. These rules are updated each code cycle, so your designer and building department set the specific path for the permit.

Garage conversions: the envelope comes first

A garage was built to shelter cars, not people. Typical conversions add wall and ceiling insulation, replace the garage door with an insulated wall and window, and address an uninsulated slab. Until the envelope is improved, any HVAC system will be oversized for the eventual room or undersized for the raw garage.

Size the mini-split for the finished, insulated space, not the garage as it stands. That is where a load calculation built from the real plans pays off.

Choosing head type and placement for small spaces

Most ADUs and garage conversions run on one or two indoor units. A studio ADU often works with a single wall head placed to throw air down the room's long axis. A one-bedroom ADU may need a second small head or a slim ducted unit serving the bedroom and bath.

  • Keep heads off the wall above the bed and away from direct throw onto seating
  • Mount on a wall that allows a short, gravity-drained condensate route where possible
  • Place the outdoor unit away from bedroom windows on both your house and the neighbors'
  • Confirm clearances for the outdoor unit with side-yard setbacks in mind

Electrical: the overlooked constraint

ADUs often add a heat pump water heater, an induction range, and sometimes an EV charger alongside the mini-split. All of that may push an older main panel past its capacity. A load calculation by the electrician, done early in design, determines whether a panel upgrade, a subpanel, or a separate service is required.

Common questions

Can my ADU share the main house's HVAC system?

Generally it shouldn't. Return air can't be shared between separate dwelling units, and the existing system was sized for the existing house. A dedicated mini-split gives the ADU independent equipment and controls.

Does a garage conversion need a permit for the mini-split?

Yes. A mini-split installation needs a mechanical permit and usually an electrical permit. In a garage conversion it is part of the larger permitted project, which also covers energy-code compliance for the newly conditioned space.

What size mini-split does an ADU need?

It depends on the ADU's size, insulation, windows, orientation, and layout. A load calculation built from the actual plans is the right way to size it. A head that is too large short-cycles and controls humidity poorly.

Is a heat pump required in a new California ADU?

Requirements depend on the energy-code cycle, the compliance path, and the climate zone. Heat pumps are often the simplest way to comply, but your designer and building department determine what's required for your project.

Reviewed and published by Statewide HVAC

Vasiliy Bardadin, owner and lead technician of Statewide HVAC, standing outdoors in a white Statewide HVAC polo.

Vasiliy Bardadin

Owner & Lead Technician

Statewide HVAC is owner-operated and Roseville-based.

Statewide HVAC is a CSLB-licensed heating and air conditioning contractor (#1023360) serving the Sacramento region from Roseville. Our guides are written for local homeowners, list their sources, and show the date they were last reviewed. About us

Questions this guide didn't cover?

We'll answer them on your project — no sales pressure.

(916) 461-3405Request Service