Win a free furnace replacement. Apply by Dec 9
CSLB #1023360

Supporting article · 7-minute read · Last reviewed October 2026

Is California banning gas furnaces? What the rules actually say in 2026

No. As of October 2026, no state or local rule requires a Sacramento-area homeowner to remove, stop repairing, or stop replacing a working gas furnace. CARB's proposed zero-emission heater standard is not final and, as drafted, would cap manufacturers' sales starting around 2030 rather than touch existing equipment; the Bay Area's zero-NOx furnace rule applies only inside the Bay Area air district. The two changes that do matter here are the 2025 Title 24 heat pump baseline for new homes and a federal rule that raises the minimum furnace efficiency to 95% AFUE for furnaces manufactured from December 18, 2028.

Reviewed by Vasiliy BardadinOwner & Lead Technician, Statewide HVAC · CSLB #1023360

On this page · 6 sections
  1. 01The short answer, rule by rule
  2. 02CARB's proposed zero-emission heater standard
  3. 03The Bay Area rule doesn't apply here
  4. 04What Title 24 changed in 2026, and what it didn't
  5. 05The federal 95% AFUE rule and the 2028 date
  6. 06If your furnace is failing now: what to weigh

The short answer, rule by rule

Most of the anxiety comes from mixing up four different rules that apply to different people. One is a state proposal that hasn't been adopted. One is a regional air district rule for the nine Bay Area counties. One is a building code that mostly governs new construction. The last is a federal efficiency standard that phases out non-condensing furnaces at the factory, not in your house.

None of the four orders an existing furnace out of a home. The table below sums up where each one stood when we reviewed the primary sources on October 26, 2026.

Gas furnace rules that come up in the Sacramento region (status as of 2026-10-26)
RuleWho it applies toStatusEffect on an existing Sacramento-area furnace
CARB Clean Space and Water Heater StandardsManufacturers selling new space and water heaters in CaliforniaProposed; not finalized, no Board hearing setNone. CARB says existing heaters can still be used and repaired after 2030
BAAQMD Rule 9-4 (furnaces)New furnaces sold or installed in the Bay Area air districtAdopted 2023; furnace zero-NOx date 2029None. Our five counties are outside the Bay Area air district
2025 Title 24 Energy CodePermitted projects statewideIn effect for permit applications from January 1, 2026Heat pump baseline is for new construction. Replacing an AC or furnace in an existing home does not trigger a statewide heat pump requirement
DOE consumer furnace standard (10 CFR 430.32)Furnaces manufactured for sale in the U.S.Final; 95% AFUE for non-weatherized gas furnaces made on or after December 18, 2028None for the furnace you have. It changes which replacement furnaces are made after 2028

CARB's proposed zero-emission heater standard

The rule behind most 'California is banning gas furnaces' headlines is the California Air Resources Board's Clean Space and Water Heater Standards. CARB's own FAQ, last updated July 13, 2026, says plainly that the regulation has not been finalized and that staff have not yet submitted a formal proposal to the Board.

The concept CARB presented at its December 11, 2025 workshop is a manufacturer sales limit, not a household mandate. Each manufacturer would get an annual cap on how many greenhouse-gas-emitting units it can sell in California. For space heaters, which includes gas furnaces, the draft limit is 40% of sales in 2030, dropping to 25% in 2045 and later. In other words, under the current draft, gas furnaces would still be sold in California after 2030, just in declining numbers.

CARB's FAQ also answers the question homeowners actually care about: you can keep using and repairing your existing space and water heaters after 2030, and the potential rule would not require anyone to replace working heating equipment. Because the rule is still a draft, the numbers and dates can change before adoption. Treat any article quoting a firm '2030 ban' as wrong on both counts.

The Bay Area rule doesn't apply here

The Bay Area Air Quality Management District adopted amendments to Rules 9-4 and 9-6 in March 2023. Rule 9-4 covers fan-type residential central furnaces, and its zero-NOx standard takes effect in 2029. Rule 9-6 covers small gas water heaters, which have a 2027 date. On November 4, 2026, the district's Board is scheduled to consider amendments to the water heater rule that would add exemptions and extend that date. Even inside the Bay Area, the district says the requirements apply only when existing equipment burns out, not before.

Sacramento, Placer, El Dorado, Nevada and Yolo counties are not in the Bay Area air district, so Rule 9-4 does not reach homes in Roseville, Folsom, Elk Grove, Auburn or Davis. Sacramento Metro AQMD's appliance NOx rule, Rule 414, covers water heaters, boilers and process heaters under 1,000,000 BTU per hour. It does not cover central furnaces. In our October 2026 review we found no Bay Area-style zero-NOx furnace rule from Sacramento Metro AQMD or Placer County APCD.

Parts of our service area fall under other local districts: Yolo-Solano AQMD, El Dorado County AQMD and Northern Sierra AQMD. If you live in one of those districts, its rule-development page is the place to confirm nothing new is pending.

What Title 24 changed in 2026, and what it didn't

California's 2025 Energy Code (Title 24, Part 6) applies to permit applications submitted on or after January 1, 2026. For new single-family homes, the prescriptive package now calls for heat pump space heating in every climate zone. A builder who wants a gas furnace instead has to show compliance through the performance path. The same code cycle added mandatory heat pump controls, including a lockout that keeps supplementary electric heat off above 35°F outdoors except during defrost or emergency operation.

For existing homes, the CEC's own 2025 summary lists 'installation of a heat pump when replacing an air conditioner in an existing single-family home' as a voluntary CALGreen element. A voluntary CALGreen element applies only where a city or county adopts it as a local reach code. Statewide, swapping out a furnace or AC in an existing house still requires a permit and whatever HERS verification applies to that equipment, but it does not require switching to a heat pump. If you want to be certain about your address, ask your city's building department whether it has adopted any local electrification reach code.

The federal 95% AFUE rule and the 2028 date

This is the rule most likely to affect a Sacramento-area furnace purchase. Under 10 CFR 430.32, non-weatherized gas furnaces manufactured before December 18, 2028 must meet at least 80% AFUE. Those manufactured on or after that date must meet at least 95% AFUE. The DOE finalized the rule in 2023. Because the standard follows the manufacture date, furnaces built before the deadline can still be sold and installed afterward until existing stock runs out.

The date is not entirely settled. In February 2026, gas utility and propane trade groups petitioned DOE to push the furnace compliance date to January 1, 2030 at the earliest, and DOE took public comment on that petition through May 27, 2026. As of October 26, 2026 we found no Federal Register notice granting it, so December 18, 2028 remains the date in the regulation. We'll update this page if it changes.

In practice, a 95% AFUE requirement means a condensing furnace with PVC venting and a condensate drain. Plenty of Sacramento-area homes have 80% furnaces in attics, hall closets or garages, vented through metal B-vent, sometimes sharing that vent with the water heater. When those units are eventually replaced with post-2028 equipment, the venting and drain work becomes part of the job. Our high-efficiency furnace venting guide walks through what that involves.

If your furnace is failing now: what to weigh

Nothing in the rules above should push you into a replacement you don't need. If a furnace has a failed ignitor, flame sensor, inducer motor or control board, repairing it remains an ordinary, legal choice. The exception is a cracked heat exchanger, which is a safety finding rather than a regulatory one.

If you're replacing anyway, these are the questions that actually change the decision in our area:

  • How old is the AC? A heat pump replaces both the AC and the furnace's heating role. If the condenser is also near the end of its life, one heat pump install often makes more sense than two separate replacements.
  • Valley floor or foothills? Winters on the valley floor are mild, which favors heat pumps. Homes at higher elevation in Placer, El Dorado and Nevada counties see more hours below freezing, and some owners there prefer a dual-fuel setup that pairs a heat pump with a gas furnace for the coldest hours.
  • Can the house take a condensing furnace easily? If your 80% furnace sits where PVC venting and a condensate drain are hard to route, that cost will show up whenever you replace it. It may be easier to deal with it now than in a post-2028 emergency swap.
  • Is the electrical panel ready? A heat pump with electric backup heat can require panel or circuit work, so get that answered before comparing quotes.
  • What does switching actually involve? Our furnace-to-heat-pump conversion guide walks through it, from the electrical circuit to the capped gas line.
  • Which incentives are actually open? Where utility HVAC rebates exist they mostly target heat pumps, and what's open differs between SMUD, Roseville Electric and PG&E territory. Our Sacramento rebates guide covers how to check current status. The federal Section 25C tax credit ended for equipment placed in service after December 31, 2025, so it no longer applies to a 2026 install.

Common questions

Do I have to replace my gas furnace because of California law?

No. As of October 2026, no state or local rule requires a homeowner in Sacramento, Placer, El Dorado, Nevada or Yolo County to remove or stop repairing a working gas furnace. CARB's proposed standard is not final, and CARB says existing heaters can still be used and repaired after 2030.

Can I still buy and install a new gas furnace in 2026?

Yes. New gas furnaces can be legally installed in existing Sacramento-area homes, and the federal minimum for non-weatherized gas furnaces made before December 18, 2028 is 80% AFUE. A permit is still required for the replacement, as it is for any furnace changeout in California.

Will 80% furnaces become illegal in 2028?

Installing an 80% furnace will not become illegal. The federal rule requires non-weatherized gas furnaces manufactured on or after December 18, 2028 to meet 95% AFUE, so manufacturers stop making 80% units while existing stock can still be sold and installed. Industry groups have petitioned DOE to delay that date, but as of October 26, 2026 no delay had been published.

Does the Bay Area's zero-NOx furnace rule apply in Roseville or Sacramento?

No. BAAQMD Rules 9-4 and 9-6 apply only within the Bay Area Air Quality Management District, which does not include the Sacramento region. Even in the Bay Area, the district says the requirements apply when existing equipment burns out, not before.

Does Title 24 require a heat pump when I replace my AC or furnace?

Not statewide. The 2025 Energy Code makes heat pump heating the prescriptive baseline for new single-family construction. For existing homes, a heat pump when replacing an AC is listed as a voluntary CALGreen measure that applies only if a city or county adopts it locally, so check with your building department.

Is there still a federal tax credit for switching to a heat pump?

No. The federal Section 25C credit ended for equipment placed in service after December 31, 2025, so 2026 installs don't qualify. Local utility rebates may still apply depending on whether your electric provider is SMUD, Roseville Electric or PG&E.

Sources

Program amounts and rules change. Confirm current terms with the source before you rely on them.

Reviewed and published by Statewide HVAC

Vasiliy Bardadin, owner and lead technician of Statewide HVAC, standing outdoors in a white Statewide HVAC polo.

Vasiliy Bardadin

Owner & Lead Technician

Statewide HVAC is owner-operated and Roseville-based.

Statewide HVAC is a CSLB-licensed heating and air conditioning contractor (#1023360) serving the Sacramento region from Roseville. Our guides are written for local homeowners, list their sources, and show the date they were last reviewed. About us

Questions this guide didn't cover?

We'll answer them on your project — no sales pressure.

(916) 461-3405Request Service