Win a free furnace replacement. Apply by Dec 9
CSLB #1023360

Nevada City · Nevada County

Heat pump repair for Nevada City's long, damp winters

Statewide HVAC, a CSLB-licensed contractor (#1023360) based in Roseville, repairs ducted and ductless heat pumps in Nevada City, and most winter calls here trace back to ice: an outdoor coil that frosts over on damp freezing nights and a defrost cycle, sensor or fan that has stopped clearing it. The rest are the usual heat pump faults, such as weak capacitors, refrigerant leaks and reversing valves, made more noticeable by how many nights a year the system has to run.

  • Reviews on Google
  • CSLB #1023360 · C-20 & C-43
  • Roseville office
  • No travel fee to Nevada City
  • Emergency calls taken after hours
  • Labor warranty on our work
Call (916) 461-3405

Get a quote

Heat Pump Repair in Nevada City

Address (optional)

By submitting you agree we may contact you by phone (incl. text) and email about your request. Message/data rates may apply. Reply STOP to opt out of texts. See Privacy and Terms.

Heat Pump Repair in Nevada City · 8 sections
  1. 01Why ice is the first suspect in Nevada City
  2. 02Before you call: a five-minute sequence
  3. 03Snow, roof drip and refrozen meltwater
  4. 04Heat pumps in a town of very old houses
  5. 05After a PG&E power shutoff
  6. 06Refrigerant leaks and how old the system is
  7. 07When the repair bill points to replacement
  8. 08Who handles heat pump repair in Nevada City

Why ice is the first suspect in Nevada City

NOAA's 1991–2020 normals for the Nevada City station, at about 2,477 feet, show roughly 49 nights a year at or below freezing and about 139 below 40°F, with around 62 inches of precipitation. That combination, cold and wet at the same time, is what loads a heat pump's outdoor coil with frost. Every one of those nights asks the defrost system to work, often several times.

A healthy defrost cycle is short and a little dramatic. Trane's homeowner guidance describes cycles that usually last three to five minutes, with the outdoor fan stopping, a swoosh as refrigerant reverses, and a plume of steam off the coil. When a defrost control, coil sensor or outdoor fan fails, the frost never fully clears, the next layer freezes on top, and within a day the coil can be encased. Heating output collapses, backup heat takes over, and the electric bill climbs. Trane's own line between normal and not: a unit that goes into defrost constantly, or cycles that keep getting longer while ice spreads, needs service.

The installer's defrost settings matter too. The 2025 California Energy Code calls for installer-adjustable defrost delay timers to be set to 90 minutes or more on new installations, and some older systems were set shorter or left at a factory default. If a technician changes a defrost setting on your system, ask what it was and why it changed.

Before you call: a five-minute sequence

Work through these in order. Each one is safe for a homeowner, and the first three resolve more no-heat calls than you might expect.

  • 1. Read the thermostat. Is it in Heat mode? Does it show AUX or EM? Emergency heat shuts the heat pump off on purpose; the 2025 code requires new thermostats on these systems to show when backup heat is running, and many older ones show it too.
  • 2. Check power. Look for a tripped breaker for the outdoor unit and for the air handler, and confirm the disconnect switch beside the outdoor unit is on. Reset a tripped breaker once. If it trips again, stop.
  • 3. Change or check the filter. Low airflow reduces heat and can make the indoor coil run hot enough to shut the system down.
  • 4. Look at the outdoor unit. Brush snow and leaves off by hand. Note whether ice is a thin frost or a thick shell, and whether a roof edge or gutter drips on it. Don't chip or pry at ice.
  • 5. Listen for a minute. A brief swoosh and steam is defrost. A steady buzz with the fan not turning, a grind, or a clatter means shut it off and call.

Snow, roof drip and refrozen meltwater

Nevada City averages about 14.5 inches of snow a year in the NOAA normals, enough to drift against an outdoor unit that sits low. Snow packed into the sides of the coil blocks airflow the same way ice does. The more common problem, though, is water from above: in older houses where the outdoor unit was tucked under an eave, snowmelt and rain fall straight onto the top of the unit and refreeze overnight, sealing the fan grille.

Defrost water has to go somewhere too. A unit set directly on a slab or on soft ground can sit in its own refrozen meltwater, with the base pan and lower coil locked in ice. On repair visits we look at where the water goes as well as at the controls. Sometimes the fix for repeat icing is a raised stand, a small roof diverter, or moving the unit a few feet, rather than another defrost board.

Heat pumps in a town of very old houses

About 43% of Nevada City's housing was built in 1939 or earlier, per Census Bureau ACS estimates, and the median home dates from 1947. That shows up in heat pump repair in two ways.

First, in a house that never had ducts, the heat pump is usually a ductless mini-split. Those systems fail in their own patterns: indoor heads with clogged filters and coils, condensate lines that back up and drip down an interior wall, and communication errors between the indoor heads and the outdoor unit, often shown as a blinking light or error code. Long line sets run around old trim and through thick walls are worth checking for kinks or damaged insulation when a single head underperforms.

Second, ducted heat pumps in older houses often feed duct systems added during later remodels, through crawlspaces and low attics. Heat pump air is warm rather than hot, and Lennox's homeowner guide notes it comes in larger volume than furnace air. Leaky or uninsulated ducts in a cold crawlspace lose that warmth before it reaches the room, which feels like a weak heat pump even when the equipment is fine. Our heat pump not heating guide covers how to tell normal lukewarm air from a real fault.

After a PG&E power shutoff

PG&E reported that its October 16, 2026 Public Safety Power Shutoff de-energized 2,137 customers in Nevada County. A heat pump stops completely during an outage, and when power comes back it may not restart the way you expect. Many systems have a built-in delay before the compressor restarts, which protects it; some thermostats lose their settings or come back in a different mode.

If the system doesn't restart after the power returns, give it a few minutes, then check the thermostat mode and both breakers. Power that comes back unevenly can damage a capacitor or control board, so a heat pump that hums but won't start after an outage is a repair call. If you ran a generator, tell us how it was connected; a heat pump drawn through an extension cord or an unapproved connection is a separate safety issue.

Refrigerant leaks and how old the system is

Low refrigerant makes a heat pump ice up faster, heat weakly and run longer. A technician should find the leak, not just add charge; our refrigerant leak guide explains how that decision is made. Systems from before about 2010 may use R-22, whose production and import ended on January 1, 2020 under EPA's phaseout schedule, which makes every recharge harder to justify. R-410A systems can still be repaired with new parts: EPA states that components used to repair existing systems are not subject to the Technology Transitions limits that apply to new installations from January 1, 2025.

When the repair bill points to replacement

Most Nevada City heat pump calls end in a repair: a capacitor, contactor, fan motor, defrost control, sensor or drain. The calls that turn into a replacement conversation are a failed compressor or reversing valve on an older unit, a second leak on an R-22 system, or a system that ices up every winter because it was undersized for a house with this much heating load. With about 4,038 heating degree days a year at the Nevada City station, a heat pump here runs far more hours than one in the valley, so wear on an aging unit adds up quickly.

If replacement makes sense, our heat pump replacement service covers the process, the Nevada City heat pump installation page covers sizing and outdoor-unit placement for this climate, and the cold-weather performance guide explains which ratings matter at the low end. A replacement needs a permit, which starts with the City and is issued by the Nevada County Building Department; routine repairs don't.

Who handles heat pump repair in Nevada City

Statewide HVAC holds CSLB license #1023360 and works from its Roseville office throughout western Nevada County. Emergency calls are taken after hours. Our heat pump repair page describes what a visit covers, and the Nevada City overview covers the town's housing, utilities and permits. If the house also has a furnace that has stopped, see furnace repair in Nevada City. Neighbors can compare heat pump installation in Grass Valley and Penn Valley. Book through the contact page.

Google reviews

What customers say on Google

Read our reviews on Google

Reviews and ratings shown live from Google Maps.

  • Loading reviews from Google…
Vasiliy Bardadin, owner and lead technician of Statewide HVAC, standing outdoors in a white Statewide HVAC polo.

Owner-operated

Meet Vasiliy.

Vasiliy Bardadin owns Statewide HVAC and works as its lead technician. The company is licensed by the California Contractors State License Board (CSLB #1023360, C-20 and C-43) and runs out of a Roseville office serving the greater Sacramento region.

Owner & Lead Technician
Vasiliy Bardadin
Since 2017
CSLB-licensed

Heat Pump Repair in Nevada City

What happens after you reach out

  1. 01

    Call or send a request.

    Tell us what the system is doing — not heating or cooling, making noise, won't start. That's enough to begin.

  2. 02

    A technician diagnoses it.

    We inspect the system and show you what we found. No guessing. No parts-cannon. The actual problem, explained plainly.

  3. 03

    You decide what happens next.

    Repair or replace, budget range, timeline. The call is yours — we lay out the options and you choose.

Heat Pump Repair in Nevada City — questions

There's a layer of frost on my outdoor unit every morning. Should I worry?

Not if it clears. Frost on cold, damp mornings is normal in Nevada City, and the defrost cycle should melt it within a few minutes, usually with steam and the fan stopped. Call if the frost thickens into solid ice, covers the top of the unit, or never clears.

My thermostat says AUX all day. Is the heat pump broken?

Possibly. Backup heat should come on during defrost and on the coldest nights, not all day in mild weather. If AUX stays on, check that the thermostat isn't in emergency heat and that the outdoor unit is running; if it isn't, book a repair.

One room's mini-split head is blinking and won't heat. Can I fix it?

You can clean the head's filter and check that its drain line isn't dripping. A blinking light is usually an error code, which a technician reads against the manufacturer's code list to find the fault.

The heat pump won't start after the power came back. What should I do?

Wait a few minutes, since many units delay the compressor after a power loss. Then check the thermostat mode and the breakers. If it hums without starting, or a breaker trips, leave it off and call for service.

Can you add refrigerant to get me through the winter?

We can, but we would rather find the leak first. Topping up without a repair usually means the same icing and weak heat return. On older R-22 systems, the cost of refrigerant makes replacement worth comparing.

Do I need a permit for a heat pump repair in Nevada City?

No. Repairs to parts such as capacitors, motors or controls don't. Replacing the heat pump does, with the application starting at the City and the permit issued by Nevada County.

Does Statewide HVAC charge a travel fee to Nevada City?

No. Statewide HVAC doesn't charge a travel fee to Nevada City, even though the office is in Roseville. The same goes for Grass Valley, Nevada City, Penn Valley, Lake Wildwood, Lake of the Pines and Meadow Vista.

More questions? See the full Heat Pump Repair service page or everything we do in Nevada City.

Sources

Heat Pump Repair in Nevada City?

Diagnosis first — honest options second.

(916) 461-3405Request Service