Weimar HVAC guide · 11 sections
- 01Furnace or AC down in Weimar? Pick the right page
- 02New England Mills, a renamed post office and an I-80 crossroads
- 03The sanatorium grounds and today's campus
- 04Why Weimar's Census numbers need a caveat
- 05What that fuel mix means for a Weimar heating decision
- 06Month by month at the Colfax station
- 07A Very High fire zone, outages and smoke
- 08Wood heat and the county air district
- 09HVAC services for Weimar homes
- 10Permits, power and propane in Weimar
- 11Hiring an HVAC contractor in Weimar
Furnace or AC down in Weimar? Pick the right page
A Weimar house can need heat in the morning and cooling by mid-afternoon in spring and fall, so failures show up in both seasons. When the furnace won't fire, or fires and then shuts down, start with furnace repair. The short-cycling guide explains why a burner keeps stopping. For a summer breakdown, AC repair covers the visit, and frozen evaporator coil explains the ice you may find on the lines.
If the house heats with propane, read the tank gauge first. A run-out looks like a broken furnace, and a propane system that ran dry should be relit carefully once the tank is refilled.
New England Mills, a renamed post office and an I-80 crossroads
Before it was Weimar, the settlement was called New England Mills. The Weimar post office opened on March 22, 1886. One family account says founder George Geisendorfer chose the name after postal officials turned down New England Mills. In 1919, a resolution in the State Senate to rename the town Argonne was defeated. Weimar sits directly beside Interstate 80, and the federal geographic names record puts the community point at 2,257 feet.
Planning for Weimar falls under the same county document as its neighbors: the Weimar/Applegate/Clipper Gap General Plan, adopted on September 22, 1980. That plan bounds its area at Weimar Cross Road to the north. It also records that the Weimar Water District supplied treated water to the Weimar Cross Road and Canyon Way area east of the freeway, while most of the plan area relied on private wells and septic systems. For HVAC work, that rural, well-and-septic setting matters more than the town's small size.
The sanatorium grounds and today's campus
Weimar's best-known landmark is institutional. The Weimar Joint Sanatorium opened in 1919 to treat tuberculosis patients who could not pay for private care, and several California counties ran it jointly. Under the later names Weimar Chest Center and Weimar Medical Center, it operated until 1972. In 1975 the property reopened for a time as Hope Village, a relocation center for Vietnamese refugees. In May 1977 a group of Seventh-day Adventists bought the 457 acres. The campus is now Weimar University, formerly Weimar Institute, with a college, an academy and a lifestyle health center. A Sacramento Bee writer described the grounds as 450 acres of manzanita, pine and oak, with the central cluster of buildings housing the institute.
This matters for an HVAC page for two reasons. First, the campus shapes the Census data for Weimar, as the next section explains. Second, mechanical work on large institutional or multi-unit buildings is a different job from a house. For that kind of building, see the commercial HVAC repair and commercial maintenance pages rather than the residential ones.
Why Weimar's Census numbers need a caveat
Weimar is not a census-designated place. Its own ZIP Code Tabulation Area, 95736, covers only about 148 acres, roughly 0.23 square miles, around the university's coordinates. The 2020 Census counted 339 people and 81 housing units there. The American Community Survey sample for that small area describes a campus core, not the scattered homes around it. Every occupied unit was renter-occupied, most units were attached or in small multi-unit buildings, and the median building dates to 1976. The margins of error are very wide, so we use those figures only to describe the core.
The houses around the Weimar crossroads fall in ZCTA 95713, a 61-square-mile tabulation area that Weimar shares with Colfax and the rural land between them. Its figures describe the wider foothill area Weimar belongs to, not Weimar alone. Of about 3,927 housing units there, about 78% are detached houses and about 9% are mobile homes, and about 79% of occupied homes are owner-occupied. The median year built is 1985, and the 1980s were the biggest building decade, with about 931 units.
| Heating fuel | Approx. homes | Share |
|---|---|---|
| Bottled or tank gas (propane) | 1,553 | about 43% |
| Electricity | 773 | about 21% |
| Wood | 710 | about 19% |
| Utility natural gas | 509 | about 14% |
| All other, including none | 108 | about 3% |
What that fuel mix means for a Weimar heating decision
Propane is the most common primary fuel in the Colfax–Weimar ZIP area, and fewer than one home in seven uses PG&E line gas. That makes the usual valley comparison, a gas furnace against a heat pump, a different question here. For most Weimar homes the comparison is tank propane against electricity, with wood as a third option.
- Keeping propane. A replacement LP furnace has to be configured for propane before start-up, with the correct orifices and gas-valve setting. A high-efficiency condensing model also needs its own vent and a condensate drain. See high-efficiency furnace venting.
- Moving to a heat pump. A heat pump replaces both the propane furnace's heating and a separate air conditioner. Many owners pair one with the existing LP furnace as a dual-fuel system for the coldest mornings. The crossover temperature guide explains how the switchover point is set.
- Checking the panel. A heat pump adds electrical load that a propane-heated house never needed, so confirm the service size first. Our heat pump panel guide covers what to check before committing.
Month by month at the Colfax station
NOAA has no normals station in Weimar. The Colfax station, about 3.9 miles to the northeast at about 2,380 feet, sits only about 120 feet above Weimar's recorded elevation, which makes it an unusually close match. These are its 1991–2020 normals for the months that matter most for heating and cooling.
- February brings the most snow. The station averages about 7.2 inches a year. February is the snowiest month, and the station records about 37 nights a year at or below freezing. Raise outdoor units off the ground and keep them out from under roof edges where snow slides off.
- Summers are still valley-hot. The station averages about 66 days a year at 90°F or above and about 9 days at 100°F or above. A system sized only for winter will fall short in July.
- Heat pump selection. With winter lows in the mid- to upper 30s, compare heat pumps on their rated output at low outdoor temperatures. Our cold-weather heat pump guide explains the ratings.
| Month | Average high | Average low | Average snowfall |
|---|---|---|---|
| December | 53.5°F | 36.1°F | 1.5 in |
| January | 54.9°F | 36.7°F | 0.9 in |
| February | 56.9°F | 37.4°F | 2.6 in |
| March | 60.3°F | 39.5°F | 1.2 in |
| July | 92.1°F | 62.5°F | none |
| August | 91.4°F | 61.1°F | none |
A Very High fire zone, outages and smoke
Every point we sampled in and around Weimar on CAL FIRE's Fire Hazard Severity Zone layer, including the community point and the campus, fell in a State Responsibility Area Very High zone. Confirm your own parcel with the CAL FIRE address lookup. In practice, keep the condenser or heat pump clear of brush, firewood stacks and leaf litter, and give it the clearance the manufacturer requires on every side.
When PG&E de-energizes lines for fire safety, a propane furnace stops along with everything else, because its igniter, control board and blower run on electricity. PG&E's Generator and Battery Rebate Program pays up to $300 per eligible account, with up to $200 more for CARE or FERA customers, in Tier 2 and 3 High Fire-Threat Districts, High Fire Risk Areas and on Enhanced Power Safety Settings circuits. PG&E lists the program as open through December 31, 2026. A permanently installed generator needs its own Placer County permit.
On smoky days, a higher-MERV filter in a properly sized filter rack helps, as long as the blower can handle the added resistance. The MERV ratings guide and the wildfire smoke guide cover the details.
Wood heat and the county air district
About one home in five in the Colfax–Weimar ZIP area heats mainly with wood, so the Placer County Air Pollution Control District's rules are worth knowing before you buy, sell or replace. Under Rule 225, Section 303, any free-standing wood stove that is not EPA Phase II certified has had to be rendered inoperable before a property changes hands since January 1, 2012. Inserts, fireplaces, cook stoves, and pellet and gas stoves are exempt.
The District's changeout program was open when we checked on November 12, 2026. For an uncertified stove, insert or fireplace used as primary heat, it listed up to $5,000 toward an electric heat pump at the standard level, or up to $10,000 for income-qualified households. It listed up to $2,500 or $5,000 toward a certified wood appliance or electric heater. The old device must still be installed when you apply. Approved vouchers are redeemed within 28 days through retailers on the District's participating list, so check that list first.
HVAC services for Weimar homes
Each page linked below explains the work in full. In Weimar, they usually come up like this:
- Furnace replacement: LP and electric furnaces in rural homes.
- Heat pump replacement: swapping an older heat pump for one rated for colder mornings.
- AC installation: adding cooling to a house that has only ever had a furnace or stove.
- Ductless mini-splits: zones, additions, shops and houses without ducts.
- Duct repair: crushed or disconnected crawlspace runs found during a replacement.
- HVAC maintenance: pre-winter checks on LP furnaces and pre-summer coil cleaning.
Permits, power and propane in Weimar
With no city government, Weimar's HVAC permits come from Placer County's Community Development Resource Agency in Auburn. Applications go through the county's e-Permits portal. For a manufactured or mobile home, the same county page sends heating and air replacements to the state Department of Housing and Community Development (HCD). A state-required ECC rater, formerly called a HERS rater, then verifies the installation. Ducts in a crawlspace often need sealing to pass, as our duct leakage test guide explains.
PG&E's Placer County service-area lists name Weimar. Pioneer Community Energy supplies the electricity for Placer County customers who have not opted out, and PG&E delivers it and sends the bill. Propane is sold by private dealers, and on a leased tank the dealer usually owns the tank and regulator. The federal 25C credit ended for equipment placed in service after December 31, 2025. Check our rebate navigation guide before counting on any incentive.
Hiring an HVAC contractor in Weimar
Ask any contractor you are considering whether they work on LP equipment, whether they will size a replacement from a load calculation, and how they will handle clearances in a Very High fire zone. Ask too who pulls the Placer County permit and schedules the ECC test. For a campus, church or other multi-unit building, ask whether they do commercial work.
Statewide HVAC holds CSLB license #1023360, classifications C-20 and C-43. Check it, or any contractor, on the CSLB license lookup. Nearby hubs include Colfax, Applegate, Meadow Vista and Auburn, and the Placer County page lists every community. For a rough range, use the cost calculator. To book, contact the office.
